technology package

The speciality of our heat storage is the technical package that was built into the engine bay. All elements that are required for the reservoir operation, such as the heat exchanger, the fresh water station, the pumps, the valves, the sensors, the expansion tank, safety groups etc. are integrated into the access area (engine bay).

This area is located within the box insulation and basically takes over the roles of the engineering room. Because of the very short tubelength, mostly in centrimetre range, there are only minimal heat losses. Operation with a single circulation pump. Connection to the household installation via only three pairs of pipes.

General Data

EBITSCH-heat-management system, especially developed for horizontally integrated multi-chamber systems with a total of only 5 connecting pipes, which are all located in the area of the insulated pass partition wall between the two chambers. With this, the outer insulation wrapping stays without permeation and thus, free of thermal bridges.

Technical Data

Fresh water module, 3x heat exchanger(heater,solar system,hot water); 7-way-multifunction valves, 2x special servomotors with position detection, sytem to fill and vent, control converter modul, control bus detection modul, control micro central control, control performance modul, flow indicator QP 2,5, continuous flow water heater 6 kW, pump Z 25 6, 16x temperature indicator PT1000, 2x level indicator, mixer, vacuum pump with accessory, 2x angular sensors

Control

Complete and storage integrated control and energy management system with outer (house) and inner (storage) unit for all control tasks at the storage and at the complete heating system.

This control and energy management system provides the immaculate functionality of the storage with all his components and of the whole heating and solar system. It has to monitor the efficient utilization of the incoming and outgoing energy.

That's why no extra or separate control system is required.

Because of it's bus technology this system is easily extendable if necessary. Heating contractors don't have to care about the control technology and its programming and adjustment.

The control system‘s ability to be connected to the internet makes worldwide monitoring, diagnosis, maintenance, and adjustment exactly for this building and it's energy sources possible. There is no need to come into the building for adjustments.

The control and energy management system consists of an outer unit (central unit) and an inner unit (storage unit). They are connected with only two lines. The outer unit is for monitoring and controlling all values, parameters and statuses of the inner unit. On a small display you can see the most important values like temperature and start status.